Logging Event Trunk-Status Global (Global Configuration) - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

logging event trunk-status global (global configuration)

To enable the trunk-status event messaging globally, use the logging event trunk-status global
command. Use the no form of this command to disable trunk-status event messaging.
Syntax Description
This command has no arguments or keywords.
Defaults Global trunk-status messaging is disabled.
Command Modes Global configuration mode
Command History Release
12.2(25)SG
Usage Guidelines If trunk-status logging event is not configured at the interface level, the global trunk-status setting takes
effect for each interface.
Examples This example shows how to globally enable link status messaging on each interface:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# logging event trunk-status global
Switch(config)# end
Switch#
Related Commands Command
logging event trunk-status global
(global configuration)
OL-27596 -01
logging event trunk-status global
no logging event trunk-status global
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
logging event trunk-status global (global configuration)
End with CNTL/Z.
Description
Enables the trunk-status event messaging on an interface.
2-405