Show Storm-Control - Cisco Catalyst 4500 Series Command Reference Manual

show storm-control

show storm-control
To display the broadcast storm control settings on the switch or on the specified interface, use the
show storm-control command.
Supervisor Engine 6-E and Catalyst 4900M chassis
Syntax Description interface-id
broadcast
multicast
Defaults
This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(19)EW
12.2(25)EW
12.2(40)SG
Usage Guidelines When you enter an interface ID, the storm control thresholds are displayed for the specified interface.
If you do not enter an interface ID, the settings are displayed for the broadcast traffic type for all ports
on the switch.
Examples This is an example of output from the show storm-control command when no keywords are entered.
Because no traffic type keyword was entered, the broadcast storm control settings are displayed.
Switch# show storm-control
Interface
---------
Gi2/1
Gi4/1
Gi4/3
Switch#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-934
show storm-control [interface-id | broadcast]
show storm-control [interface-id | broadcast | multicast]
(Optional) Specifies the interface ID for the physical port.
(Optional) Displays the broadcast storm threshold setting.
(Optional) Displays the multicast storm threshold setting.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for the 10-Gigabit Ethernet interface.
Added support for the Supervisor Engine 6-E and Catalyst 4900M chassis.
Filter State Upper
------------- -------
Forwarding
Forwarding
Forwarding
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Lower Current
------- -------
30.00% 30.00% N/A
30.00% 30.00% N/A
30.00% 30.00% N/A
OL-27596 -01