Logging Event Trunk-Status (Interface Configuration) - Cisco Catalyst 4500 Series Command Reference Manual

logging event trunk-status (interface configuration)

logging event trunk-status (interface configuration)
To enable the trunk-status event messaging on an interface, use the logging event trunk-status
command. Use the no form of this command to disable the trunk-status event messaging. Use the
logging event trunk-status use-global command to apply the global trunk-status setting.
Defaults
Global trunk-status messaging is enabled.
Command Modes Interface configuration mode
Command History Release
12.2(25)SG
Usage Guidelines
To enable system logging of interface state-change events on a specific interface, enter the
logging event trunk-status command in interface configuration mode.
To enable system logging of interface state-change events on all interfaces in the system, enter the
logging event trunk-status use-global command in global configuration mode. All interfaces without
the state change event configuration use the global setting.
Examples
This example shows how to enable logging event state-change events on interface gi11/1:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# interface gi11/1
Switch(config-if)# logging event trunk-status
Switch(config-if)# end
Switch#
This example shows how to turn off logging event trunk status regardless of the global setting:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# interface gi11/1
Switch(config-if)# no logging event trunk-status
Switch(config-if)# end
Switch#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-406
logging event trunk-status
no logging event trunk-status
logging event trunk-status use-global
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
End with CNTL/Z.
End with CNTL/Z.
OL-27596 -01