Cisco Catalyst 4500 Series Command Reference Manual page 301

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
name name
role role
Defaults The importance is 1.
No keywords are defined.
The power level is 10.
The name is the short version of the interface name; for example, Gi1.2 for Gigabit Ethernet 1/2.
Command Modes Interface Configuration
Command History Release
12.2(52)SG
Usage Guidelines
To return the importance and level values to the default settings, use the default energywise
importance and the default energywise level commands.
Examples
This example shows how to enable and configure EnergyWise on a PoE port:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# energywise domain cisco secret cisco protocol udp port 43440 ip 2.2.4.30
Switch(config)# interface Gi1.2
Switch(config-if)# energywise level 10 recurrence importance 90 at 0 8 * * *
Switch(config-if)# energywise level 0 recurrence importance 90 at 0 20 * * *
Switch(config-if)# energywise inportance 50
Switch(config-if)# energywise name lobbyInterface.3
Switch(config-if)# energywise role role.lobbyaccess
Switch(config-if)# end
Note
OL-27596 -01
(Optional) Specifies the EnergyWise-specific port name.
For the name value:
You can enter alphanumeric characters and symbols such as #, (, %, ! or
•
&.
Do not use an asterisk (*) or a blank space between the characters and
•
symbols.
(Optional) Specifies the role of the port in the domain. For example,
lobbyport.
For the role value:
You can enter alphanumeric characters and symbols such as #, (, %, ! or
•
&.
Do not use an asterisk (*) or a blank space between the characters and
•
symbols.
Modification
This command was introduced.
Recurrence takes effect within the minute specified, rather than exactly on the minute; it could
occur as much as 60-seconds late.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
energywise (interface configuration)
End with CNTL/Z.
2-243