Step 5: Configuring The Dns Settings - Cisco SCE 1000 Installation And Configuration Manual

Initial System Configuration
E
XAMPLE
Following is a sample time setting dialog. In addition to setting the time zone, time and date are
changed, and SNTP unicast updates are configured.
Would you like to enter the Time settings menu? [no]: y
Enter time zone name [UTC]: ISR
Enter time zone minutes offset from UTC: 120
The local time and date is 15:35:23 ISR FRI July 19 2002
Would you like to set a new time and date? [no]: y
This change will take effect immediately both on the system clock and the
calendar; it will also set the time zone you entered. Are you sure?
[yes/no]: y
Enter new local time and date: 14:35:23 19 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
Would you like to enter the SNTP configuration menu? [no]: y
Enable SNTP broadcast client? [no]: y
Enter time interval in seconds between unicast updates [900]:
Would you like to configure SNTP unicast servers? [no]: y
Enter IP address or hostname of SNTP unicast server: 10.1.1.1

Step 5: Configuring the DNS Settings

The DNS configuration menu defines the IP address of the domain name server, which is used for
DNS lookup, as well as the default domain name, which is used to complete unqualified host
names.
You may choose to skip the DNS configuration menu if you wish to accept all default values.
To configure DNS settings, complete the following steps:
Enter the DNS settings menu.
Step 1
Would you like to enter the DNS configuration menu? [no]: y
Type y and press Enter.
The DNS settings dialog begins.
Enable or disable DNS lookup.
Step 2
Enable IP DNS-based hostname translation? [yes]:
If you choose to disable DNS lookup, skip the rest of this section and go to
the RDR Formatter Destination
irrelevant when DNS lookup is disabled.
Type the default domain name to be used, and press Enter.
Step 3
Note that there is no default domain name.
You may accept the default domain name or enter a new one.
Enter default domain name []:
Step 4 Type the IP address of the primary domain name server and press Enter.
Enter Primary DNS IP address:
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-10
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
:
To enable DNS lookup, press Enter.
•
To disable DNS lookup, type n and press Enter.
•
(on page 5-11). The rest of the dialog is not presented, as it is
Step 6: Configuring
OL-7821-04