Sce 1000 Installation Checklist - Cisco SCE 1000 Installation And Configuration Manual

Chapter 2 Introduction to the SCE Platform

SCE 1000 Installation Checklist

To assist you with your installation and to provide a historical record of what was done by whom,
photocopy the following SCE 1000 Installation Checklist. Indicate when each procedure or
verification is completed. When the checklist is completed, place it in your site log along with the
other records for your new SCE 1000 platform.
Table 2-5
Task
Date SCE 1000 received
SCE 1000 and all accessories unpacked
Safety recommendations and guidelines reviewed
Topology verified: number of SCE 1000 platforms, number of links, and
whether inline or receive-only
Installation Checklist copied
Site log established and background information entered
Site power voltages verified
Site environmental specifications verified
Required passwords, IP addresses, device names, and so on, needed for initial
configuration available (refer to Setup Command Parameters)
Required tools available
Network connection equipment available
SCE 1000 mounted in rack (optional)
AC/DC power cables connected to AC/DC sources and SCE 1000 platform
Console port set for 9600 baud, 8 data bits, no parity, and 1 stop bit (9600
8N1)
ASCII terminal attached to console port
FE management port is operational
GBE line ports operational
Network interface cables and devices connected
System power turned on
System boot complete (SYSTEM–UP LED is on)
Correct hardware configuration displayed after system banner appears
OL-7821-04
SCE 1000 Installation Checklist
Cisco SCE 1000 2xGBE Installation and Configuration Guide
SCE 1000 Installation Checklist
Verified Date
By
2-7