Configuring The Gbe Interface Parameters; Configuring Auto-Negotiation - Cisco SCE 1000 Installation And Configuration Manual

Chapter 6 Cabling the Line Ports and Completing the Installation
Figure 6-2: External Splitting Topology

Configuring the GBE Interface Parameters

By default, the SCE 1000 GBE line interface ports are configured with auto-negotiation disabled.
The procedure for enabling auto-negotiation for the GBE line interface ports is explained in the
following section.
Auto-negotiation must be disabled when the SCE 1000 is deployed via an external optical splitter
Note
(receive-only topology)
.
If you change any parameters, you must save the new configuration settings.
Note
Type copy running-config startup-config, and press Enter

Configuring Auto-Negotiation

By default, the SCE 1000 line interface ports are configured with auto-negotiation enabled.
However, when using an external splitter, the auto-negotiation must be disabled.
In order to prevent errors when in bypass mode, the system must be configured so that the speed and
Note
duplex of both line interfaces is the same.
If you change any parameters, you must save the new configuration settings.
Note
Type copy running-config startup-config, and press Enter.
OL-7821-04
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Connecting the line ports to the network
6-3