Trimming Using The Strip Line Mark - Cisco GS7000 Installation And Operation Manual

Trimming Using the Strip Line Mark

2 If the center conductor extends past the CUT stanchion on the housing, trim the pin flush with the end of
the CUT stanchion.
3 Remove any burrs or sharp edges from the trimmed end of the pin.
Trimming Using the Strip Line Mark
To trim long pins using the strip line mark on the housing, follow these steps.
1 Place the connector above the entry port so that it lines up with its installed position.
2 If the center conductor extends past the STRIP line on the housing, trim the pin flush with the STRIP
line.
3 Remove any burrs or sharp edges from the trimmed end of the pin.
Cisco GS7000 Super High Output Intelligent Node Installation and Operation Guide
28
Installation