Step 4: Configuring Time Settings - Cisco SCE 1000 Installation And Configuration Manual

Initial System Configuration
To change the passwords, complete the following steps:
The default User password is displayed.
Step 1
Step 2 The default Admin password is displayed.
The default Root password is displayed.
Step 3
Configure password encryption. By default, password encryption is not enabled.
Step 4
E
XAMPLE
Following is an example of changing all passwords. Password encryption is not enabled (default).
Enter a User password [cisco]: userin
Enter an Admin password [cisco]: mng123
Enter a Root password [cisco]: cistech
Enable passwords encryption? [no]:

Step 4: Configuring Time Settings

The time settings menu configures all time and date related parameters in the system. The time
settings menu includes the following:
•
•
•
•
You must enter the time setting menu in order to configure SNTP settings. You may choose to
skip the time settings menu if you wish to accept all default values.
Unlike all other settings defined in the system configuration, setting the time is done immediately and
Note
not at the end of the setup process.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-8
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
To accept the displayed value, press Enter.
•
• To change the value, type the desired string and press Enter.
To accept the displayed value, press Enter.
•
To change the value, type the desired string and press Enter.
•
• To accept the displayed value, press Enter.
• To change the value, type the desired string and press Enter.
To disable password encryption, press Enter.
•
To enable password encryption, type y and press Enter.
•
:
Time zone
Local time
Date
SNTP menu
OL-7821-04