Organization - Cisco SCE 1000 Installation And Configuration Manual

Organization

Organization
The major sections of this guide are as follows:
Chapter
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Appendix A
Cisco SCE 1000 2xGBE Installation and Configuration Guide
viii
Title
Introduction
Overview ("Introduction
to the SCE Platform" on
page 2-1)
Topology (on page 3-1)
Installation and
Maintenance (on page 4-
1)
Connecting the
Management Interfaces
and Performing Initial
System Configuration (on
page 5-1)
Cabling the Line Ports
and Completing the
Installation (on page 6-1)
Basic SCE 1000 Platform
Operations (on page 7-1)
Troubleshooting (on page
8-1)
The External Optical
Bypass Module (on page
A-1)
Description
This chapter provides a brief introduction to Cisco Service
Control.
This chapter provides a hardware overview of the SCE
1000 platform.
This chapter describes the possible deployment topologies
of the SCE 1000 and explains how various aspects of the
topology determine the configuration of the system.
This chapter explains how to install a SCE 1000 platform
in a rack or in a general tabletop installation and how to
install or replace the power supply units and fan modules.
This chapter explains how to connect the SCE 1000
platform to a local console and perform the initial system
configuration via the setup wizard that runs automatically.
This chapter provides instructions for cabling the Gigabit
Ethernet ports for one SCE 1000 topologies and for
configuring Gigabit Ethernet (GBE) interface parameters.
This chapter describes how to start up the SCE 1000
platform, reboot, and shutdown. It also describes how to
manage configurations.
This chapter provides basic system startup troubleshooting
information.
This appendix explains how to install the optional external
optical bypass module.
Preface
OL-7821-04