Cisco SCE 1000 Installation And Configuration Manual page 81

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Enter On-failure behavior:
1- bypass
2- cutoff
Enter your choice [1]:
Specify the admin status of the SCE 1000 after abnormal boot.
Step 4
Enter admin status of the SCe after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
The following examples present the procedure for configuring the topology-related parameters for
various topologies. Refer the
summary of appropriate values for the parameters for each topology.
E
XAMPLE
Following is a sample topology configuration for a topology using an external switch.
All other parameter values are automatically assigned by the system as follows:
Link bypass mode on-failure — Bypass
•
Admin status of the SCE after abnormal boot — Operational
•
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]: 2
E
XAMPLE
Following is a sample topology configuration for a non-redundant bump-in-the-wire (inline)
topology. All values are the system default values, so it is not necessary to type in the response.
Simply press enter at each line.
Connection mode — Inline
•
For a non-redundant topology, link bypass on-failure should be Bypass, so that traffic
•
continues to flow through the link.
• After operation of the system resumes, and the SCE 1000 reboots, the SCE 1000 will resume
operation. (Admin status after abnormal reboot is Operational.)
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
Enter On-failure behavior:
1- Bypass
2- Cutoff
Enter your choice [1]:
Enter admin status of the SCe after abnormal boot:
1- Operational
2- Not-Operational
OL-7821-04
To specify Cutoff, type 2 and press Enter.
•
To specify Not-Operational status after abnormal boot, press Enter.
•
• To specify Operational status after abnormal boot, type 1 and press Enter.
Topology Configuration Summary Table
#1:
#2:
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Initial System Configuration
(on page 3-9) for a
5-19