Cisco SCE 1000 Installation And Configuration Manual page 92

Connecting the line ports to the network
To configure GBE auto-negotiation for speed and duplex for the first GBE port (subscriber side)
interface:
Step 1 To enter the Global Configuration Mode, at the SCE 1000# prompt, type configure, and press
Enter.
The SCE 1000(config)# prompt appears.
To enter the first GBE port interface, type interface GigabitEthernet 0/1, and press Enter.
Step 2
The SCE 1000(config if)# prompt appears.
Type auto-negotiate and press Enter.
Step 3
The SCE 1000(config if)# prompt appears.
Step 4 To return to Global Configuration Mode, type exit and press Enter.
The SCE 1000(config)# prompt appears.
Follow the next procedure to configure auto-negotiation for the second GBE port interface
To configure speed and duplex for the second GBE port (network side) interface:
At the SCE 1000(config)# prompt, to enter the second GBE port interface, type interface
Step 1
GigabitEthernet 0/2, and press Enter.
The SCE 1000(config if)# prompt appears.
Step 2 Type auto-negotiate and press Enter.
The SCE 1000(config if)# prompt appears.
To return to Global Configuration Mode, type exit and press Enter.
Step 3
The SCE 1000(config)# prompt appears.
To exit Global Configuration Mode, type exit and press Enter.
Step 4
The SCE 1000# prompt appears.
Auto-negotiation must be disabled when the SCE 1000 is deployed via an external optical splitter (i.e.
Note
receive-only topology).
Cisco SCE 1000 2xGBE Installation and Configuration Guide
6-4
Chapter 6 Cabling the Line Ports and Completing the Installation
OL-7821-04