Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 78

Creating a Cisco SME Cluster Using the Cisco SME Wizard
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Step 2 A Store Keyshares screen opens. After the smart card applet finishes loading, click Next.
When entering smart card information, note the following:
• Be sure that the smart card reader is connected using the USB port (see the
Drivers" section on page 2-17
• When you insert a smart card into the reader, the card will be verified. You will be prompted to
initialize the card if the card has not been previously initialized.
For each smart card, each Cisco SME Recovery Officer must login and enter the smart card pin.
•
Make sure that you have the correct smart card drivers installed before proceeding.
•
Step 3 Enter the switch login information (username and password used to log in to Fabric Manager), the PIN
number for the smart card, and a label that will identify the smart card. The PIN number and label were
defined during the smart card initialization. Click Next.
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
4-16
in Chapter 2, "Getting Started").
Chapter 4 Cisco SME Cluster Management
"Installing Smart Card
OL-18091-01, Cisco MDS NX-OS Release 4.x