Configuring Cfs Regions For Fc-Redirect; Enabling Cisco Sme Services - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Appendix F Planning For Cisco SME Installation
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•
To know more about installing Fabric Manager, refer to the
Note
Client, and Enabling HTTPS" section on page 2-12
Configuration

Configuring CFS Regions For FC-Redirect

To configure the CFS regions for FC-Redirect, do the following tasks:
Configure a switch in the CFS region as shown in the following example:
Step 1
switch# config t
switch# cfs region 2
switch# fc-redirect
switch# end
Repeat this step for all the switches that are included in the specified region.
Step 2 Confirm all the required switches are available in the CFS region by entering the show fc-redirect
peer-switches command. Refer to the
To migrate existing Cisco SME installations to CFS regions for FC-Redirect, delete all the existing
Step 3
FC-Redirect configurations created by the switches in other regions from each switch. To remove the
configurations, perform the following steps:
a.
b.
Note

Enabling Cisco SME Services

To enable Cisco SME services, do the following tasks:
•
•
OL-18091-01, Cisco MDS NX-OS Release 4.x
Ensure that the Cisco Fabric Manager login name and password is the same as the switch login name
and password.
Select the appropriate database.
Select the appropriate authentication mode.
Select HTTPS during the installation.
Guide.
Obtain a list of all FC-Redirect configurations by entering the show fc-redirect configs. Refer to
the "show fc-redirect configs" section on page
Remove all configurations created by the switches in other regions by using the clear fc-redirect
configs command. The configurations are removed from the switches but the switches remain active
in the region in which they are created.
For more information, refer to the
Enable clustering on all the Cisco SME switches. For more information, refer to the
Clustering" section on page
Enable Cisco SME services using either Fabric Manager or Device Manager. For more information,
refer to the "Enabling Cisco SME" section on page
and Cisco MDS 9000 Family Fabric Manager
"show fc-redirect peer-switches" section on page
A-33.
"clear fc-redirect config" section on page
2-3.
2-6.
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
Preconfiguration Tasks
"Installing Fabric Manager, Fabric Manager
A-3.
A-34.
"Enabling
F-5