Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 165

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Using the Command Line Interface to Configure
SME
This chapter contains information about Cisco Storage Media Encryption basic configuration using the
command line interface (CLI). It contains the following sections:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Caution Before a reboot or before making any changes to the Cisco SME configuration, including adding or
deleting SME interfaces, you must enter the copy running-config startup-config CLI command.
SME Configuration Tasks
The process of configuring SME on an MDS-18/4 module or Cisco MDS 9222i involves a number of
configuration tasks that should be followed in chronological order.
The configuration tasks included in this process are the following:
1.
OL-18091-01, Cisco MDS NX-OS Release 4.x
SME Configuration Tasks, page 7-1
Enabling and Disabling SME Clustering, page 7-2
Enabling and Disabling the Cisco SME Service, page 7-2
Creating the SME Interface, page 7-2
Deleting the SME Interface, page 7-3
Creating the SME Cluster, page 7-3
Setting the SME Cluster Security Level, page 7-4
Setting Up the Cisco SME Administrator and Recovery Officer Roles, page 7-5
Adding an SME Interface from a Local or Remote Switch, page 7-5
Configuring Unique or Shared Key Mode, page 7-6
Enabling and Disabling Automatic Volume Groups, page 7-6
Enabling and Disabling Tape Compression, page 7-7
Enabling and Disabling Key-on-Tape, page 7-7
Configuring a Tape Volume Group, page 7-8
Viewing Cisco SME Cluster, Internal, and Transport Information, page 7-8
Enable clustering on the MDS-18/4 module switch.
C H A P T E R
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
7
7-1