Adding Tape Volume Groups
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Adding Tape Volume Groups
To add tape volume groups to an existing tape group, follow these steps:
Click Volume Groups. Click Create.
Step 1
Enter the new volume group name and configure a filter that Cisco SME will use to match volumes for
Step 2
that volume group. Select from the following:
•
•
•
Overlapping ranges are not recommended. If there are overlapping ranges, then Cisco SME places the
Note
volume based on the lexicographic ordering of the volume group.
If there is not a direct match, then the volumes will be placed in the default volume group.
Note
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
5-14
None—Used only if you want to import volume groups into another volume group (see
Volume Groups, page
6-12).
Regex—Cisco SME will place the volume if the barcode matches the expression.
Ranges—Cisco SME will place the volume within a specific barcode range.
Chapter 5
Cisco SME Tape Configuration
Importing
OL-18091-01, Cisco MDS NX-OS Release 4.x