Interface Sme - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Appendix A Cisco SME CLI Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

interface sme

To configure the Cisco SME interface on a switch, use the interface sme command. To remove the
interface, use the no form of the command.
Syntax Description
slot
port
Defaults Disabled.
Command Modes
Configuration mode.
Command History Release
3.2(2c)
Usage Guidelines To use this command, clustering must be enabled using the feature cluster command and Cisco SME
services must be activated using the feature sme command.
Once you have configured the interface, use the no shutdown command to enable the interface.
To delete the Cisco SME interface, you must first remove the switch from the cluster. Use the no sme
cluster command to remove the switch from the cluster and then use the no interface command to delete
the interface.
The interface commands are available in the (config-if) submode.
Examples The following example configures and enables the Cisco SME interface on the MSM-18/4 module slot
and the default Cisco SME port:
switch# config terminal
switch(config)# interface sme 3/1
switch(config-if)# no shutdown
Related Commands Command
show interface sme
shutdown
OL-18091-01, Cisco MDS NX-OS Release 4.x
interface sme slot /port
no interface sme slot /port
Identifies the number of the MSM-18/4 module slot.
Identifies the number of the Cisco SME port.
Modification
This command was introduced.
Description
Displays interface information.
Enables or disables an interface.
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
interface sme
A-15