Configuring And Starting The Cisco Sme Interface; Configuring And Starting An Cisco Sme Interface Using Device Manager - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Cisco SME Interface Configuration
This chapter describes how to configure and start Cisco SME interfaces using Fabric Manager and
Device Manager. For information on configuring and starting Cisco SME interfaces using the CLI, refer
to the Cisco MDS 9000 Family CLI Configuration Guide.
After completing the preliminary tasks described in
the Cisco SME interface on a Cisco MDS switch with an installed MSM-18/4 module or on a
Cisco MDS 9222i switch.
This section contains the following topics:
•
•
•
•
•
•

Configuring and Starting the Cisco SME Interface

Cisco SME interfaces are configured either by using the Device Manager or the CLI. For information
about creating Cisco SME interfaces using the CLI, see
to Configure SME."
This section describes the following:
•
•

Configuring and Starting an Cisco SME Interface Using Device Manager

To configure and create an Cisco SME interface using Device Manager, follow these steps:
Open the Device Manager for the switch that needs to have the Cisco SME interface defined.
Step 1
From the Admin menu, select Interface.
Step 2
From the Interface menu, select SME > Interfaces. This opens SME Interfaces in a new window.
Step 3
OL-18091-01, Cisco MDS NX-OS Release 4.x
Configuring and Starting the Cisco SME Interface, page 3-1
Saving Your Interface Configurations, page 3-3
Adding Cisco SME Interfaces to a Cisco SME Configuration, page 3-4
Viewing Cisco SME Interface Information Using the CLI, page 3-6
Removing (Unbinding) Cisco SME Interfaces from a Cisco SME Cluster, page 3-7
Deleting Switches From a Cisco SME Cluster, page 3-8
Configuring and Starting an Cisco SME Interface Using Device Manager, page 3-1
Viewing Cisco SME Interfaces in Fabric Manager Web Client, page 3-3
C H A P T E R
Chapter 2, "Getting Started,"
Chapter 7, "Using the Command Line Interface
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
3
you need to configure
3-1