Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 219

Appendix A Cisco SME CLI Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show fc-redirect active-configs
To display all active configurations on a switch, use the show fc-redirect active-configs command.
Syntax Description
This command has no arguments or keywords.
Defaults
None.
Command Modes EXEC mode.
Command History Release
3.2(2c)
Usage Guidelines
This command is used to verify if there are active configurations running on the switch during the
following procedures:
•
•
Active configuration implies configurations created by applications running on the current switch or
Note
applications created on remote switches, except the targets and hosts connected to the local switch.
Examples The following example displays the active configurations running on the switch:
switch# show fc-redirect active-configs
Config#1
==========
Appl UUID = 0x00D8 (ISAPI CFGD Service)
SSM Slot = 2
SSM Switch WWN = 20:00:00:05:30:00:90:9e (LOCAL)
Vt PWWN = 2f:ea:00:05:30:00:71:64
Tgt PWWN = 21:00:00:20:37:38:63:9e (LOCAL)
Local Host PWWN = 21:00:00:e0:8B:0d:12:c6
Config#2
==========
Appl UUID = 0x00D8 (ISAPI CFGD Service)
SSM Slot = 2
SSM Switch WWN = 20:00:00:05:30:00:90:9e (LOCAL)
Vt PWWN = 2f:ea:00:05:30:00:71:65
Tgt PWWN = 21:00:00:20:37:18:67:2c
Local Host PWWN = 21:00:00:e0:8B:0d:12:c6
Config#3
OL-18091-01, Cisco MDS NX-OS Release 4.x
show fc-redirect active-configs
Modification
This command was introduced.
Downgrading from a Cisco SAN-OS 3.2(1) image (supporting FC-Redirect) to an older image where
FC-Redirect is not supported.
Decommissioning a local switch.
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
show fc-redirect active-configs
A-31