Configuring Bbsm Radius Settings For A User Group - Cisco 2509 - Router - EN User Manual

Chapter 6 Setting Up and Managing User Groups
Step 7

Configuring BBSM RADIUS Settings for a User Group

Note
Step 1
Step 2
Step 3
Step 4
78-14696-01, Version 3.1
To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
BBSM RADIUS represents only the BBSM RADIUS VSA. You must configure
both the IETF RADIUS and BBSM RADIUS attributes.
To hide or display BBSM RADIUS attributes, see
Options for Non-IETF RADIUS Attributes, page
authorization to a particular group persists, even when you remove or replace the
associated AAA client; however, if you have no AAA clients of this (vendor) type
configured, the VSA settings do not appear in the group configuration interface.
To configure and enable BBSM RADIUS attributes to be applied as an
authorization for each user in the current group, follow these steps:
Confirm that your IETF RADIUS attributes are configured properly.
For more information about setting IETF RADIUS attributes, see
IETF RADIUS Settings for a User Group, page
In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
From the Jump To list at the top of the page, choose RADIUS (BBSM).
Configuration-specific User Group Settings
User Guide for Cisco Secure ACS for Windows Server
Setting Protocol Configuration
3-16. A VSA applied as an
Configuring
6-37.
6-49