Configuring Tacacs+ Settings For A User Group - Cisco 2509 - Router - EN User Manual

Chapter 6 Setting Up and Managing User Groups
Step 4
Step 5
Step 6
Step 7

Configuring TACACS+ Settings for a User Group

Note
Step 1
Step 2
Step 3
78-14696-01, Version 3.1
Under the Downloadable ACLs section, click the Assign PIX ACL check box.
Select a PIX ACL from the list.
To save the group settings you have just made, click Submit.
For more information, see
To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
Perform this procedure to configure and enable the service/protocol parameters to
be applied for the authorization of each user who belongs to the group. For
information on how to configure settings for the Shell Command Authorization
Set, see Configuring a Shell Command Authorization Set for a User Group,
page 6-31.
To display or hide additional services or protocols, click Interface
Configuration, click TACACS+ (Cisco IOS), and then select or clear items in the
group column, as applicable.
To configure TACACS+ settings for a user group, follow these steps:
In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
From the Jump To list at the top of the page, choose TACACS+.
Result: The system displays the TACACS+ Settings table section.
Configuration-specific User Group Settings
Saving Changes to User Group Settings, page
User Guide for Cisco Secure ACS for Windows Server
6-53.
6-29