Setting Nortel Radius Parameters For A User - Cisco 2509 - Router - EN User Manual

Advanced User Authentication Settings
Step 4

Setting Nortel RADIUS Parameters for a User

Note
Step 1
User Guide for Cisco Secure ACS for Windows Server
7-48
Do one of the following:
If you are finished configuring the user account options, click Submit to
•
record the options.
To continue to specify the user account options, perform other procedures in
•
this chapter, as applicable.
The Nortel RADIUS parameters appear only if all the following are true:
A AAA client has been configured to use RADIUS (Nortel) in Network
•
Configuration.
The Per-user TACACS+/RADIUS Attributes check box is selected under
•
Advanced Options in the Interface Configuration section.
User-level RADIUS (Nortel) attributes you want to apply have been enabled
•
under RADIUS (Nortel) in the Interface Configuration section.
Nortel RADIUS represents only the Nortel proprietary attributes. You must
configure both the IETF RADIUS and Nortel RADIUS attributes. Proprietary
attributes override IETF attributes.
To hide or display Nortel RADIUS attributes, see
Options for Non-IETF RADIUS Attributes, page
authorization to a particular user persists, even when you remove or replace the
associated AAA client; however, if you have no AAA clients of this (vendor) type
configured, the VSA settings do not appear in the user configuration interface.
To configure and enable Nortel RADIUS attributes to be applied as an
authorization for the current user, follow these steps:
Perform Step 1 through Step 3 of
Result: The User Setup Edit page opens. The username being added or edited is
at the top of the page.
Chapter 7 Setting Up and Managing User Accounts
Setting Protocol Configuration
3-16. A VSA applied as an
Adding a Basic User Account, page 7-5.
78-14696-01, Version 3.1