Cisco 2509 - Router - EN User Manual page 238

Advanced User Authentication Settings
Before You Begin
•
•
To configure TACACS+ settings for a user, follow these steps:
Click Interface Configuration and then click TACACS+ (Cisco IOS). In the
Step 1
TACACS+ Services table, under the heading User, ensure that the check box is
selected for each service/protocol you want to configure.
Step 2 Perform Step 1 through Step 3 of
Result: The User Setup Edit page opens. The username being added or edited is
at the top of the page.
Scroll down to the TACACS+ Settings table and select the bold service name
Step 3
check box to enable that protocol; for example (PPP IP).
To enable specific parameters within the selected service, select the check box
Step 4
next to a specific parameter and then do one of the following, as applicable:
•
•
Tip
To employ custom attributes for a particular service, select the Custom
Step 5
attributes check box under that service, and then specify the attribute/value in the
box below the check box.
User Guide for Cisco Secure ACS for Windows Server
7-24
For the TACACS+ service/protocol configuration to be displayed, a AAA
client must have been configured to use TACACS+ as the security control
protocol.
In the Advanced Options section of Interface Configuration, ensure that the
Per-user TACACS+/RADIUS Attributes check box is selected.
Select the Enabled check box.
Specify a value in the corresponding attribute box.
To specify ACLs and IP address pools, enter the name of the ACL or pool as
defined on the AAA client. Leave the box blank if the default (as defined on
the AAA client) should be used. For more information about attributes, see
Appendix B, "TACACS+ Attribute-Value Pairs,"
documentation. For information on assigning a PIX ACL, see
PIX ACL to a User, page
An ACL is a list of Cisco IOS commands used to restrict access to or from
other devices and users on the network.
Chapter 7 Setting Up and Managing User Accounts
Adding a Basic User Account, page
7-21.
7-5.
or your AAA client
Assigning a
78-14696-01, Version 3.1