Cisco 2509 - Router - EN User Manual page 264

Advanced User Authentication Settings
To hide or display Juniper RADIUS attributes, see
Note
Options for Non-IETF RADIUS Attributes, page
authorization to a particular user persists, even when you remove or replace the
associated AAA client; however, if you have no AAA clients of this (vendor) type
configured, the VSA settings do not appear in the user configuration interface.
To configure and enable Juniper RADIUS attributes to be applied as an
authorization for the current user, follow these steps:
Perform Step 1 through Step 3 of
Step 1
Result: The User Setup Edit page opens. The username being added or edited is
at the top of the page.
Before configuring Juniper RADIUS attributes, be sure your IETF RADIUS
Step 2
attributes are configured properly. For more information about setting IETF
RADIUS attributes, see
Step 3 In the Juniper RADIUS Attributes table, to specify the attributes that should be
authorized for the user, follow these steps:
a.
b.
c.
Do one of the following:
Step 4
•
•
User Guide for Cisco Secure ACS for Windows Server
7-50
Setting IETF RADIUS Parameters for a User, page
Select the check box next to the particular attribute.
Further define the authorization for that attribute in the box next to it.
Continue to select and define attributes, as applicable.
For more information about attributes, see
Attributes," or your AAA client documentation.
If you are finished configuring the user account options, click Submit to
record the options.
To continue to specify the user account options, perform other procedures in
this chapter, as applicable.
Chapter 7 Setting Up and Managing User Accounts
Setting Protocol Configuration
3-16. A VSA applied as an
Adding a Basic User Account, page
Appendix C, "RADIUS
7-5.
7-38.
78-14696-01, Version 3.1