Cisco 8831NR Administration Manual page 79

Cisco Unified IP Conference Phone Settings
Set Up IP Phone to Not Use DHCP
When not using DHCP, you must configure the IP address, subnet mask, TFTP server, and default router
locally on the conference station.
Procedure
Step 1
Press Apps and choose Admin Settings > Network Setup > Ethernet Setup > IPv4 Setup.
Step 2 To disable DHCP and manually set an IP address:
a) Set DHCP Enabled to No.
b) Enter the static IP address for the conference station.
c) Enter the subnet mask.
d) Enter the default router IP addresses.
e) Set Alternate TFTP Server to Yes, and enter the IP address for TFTP Server 1.
Step 3 Press Apply, and then press Save.
Related Topics
Security Setup Menu
The Security Setup menu provides information about various security settings. It provides access to the Trust
List File screen and the 802.1x authentication.
Access the Security Configuration menu from Apps > Admin Settings > Security Setup
The following table describes the options in this menu.
Table 22: Security Menu Settings
Option
Security Mode
Set DHCP, on page 65
Set Subnet Mask, on page 66
Set IP Address, on page 66
Set Default Router, on page 66
Set Alternate TFTP, on page 67
Set TFTP Server 1, on page 67
Cisco Unified IP Conference Phone 8831 and 8831NR Administration Guide
Description
Displays the security mode that is
set for the phone.
Set Up IP Phone to Not Use DHCP
To Change
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
69