Cisco 8831NR Administration Manual page 160

Cisco Unified Communications Manager User Addition
Cisco Unified Communications Manager User Addition
This section describes steps for adding a user to Cisco Unified Communications Manager. Follow one of the
procedures in this section, depending on your operating system and the manner in which you are adding the
user.
Add User from External LDAP Directory
If you added a user to an LDAP Directory (a non–Cisco Unified Communications Server directory), you can
immediately synchronize that directory to the Cisco Unified Communications Manager on which you are
adding this same user and the user's phone by following these steps.
Procedure
Step 1 Log onto Cisco Unified Communications Manager Administration.
Step 2
Choose System > LDAP > LDAP Directory.
Step 3 Use the Find button to locate your LDAP directory.
Step 4
Select on the LDAP directory name.
Step 5 Select Perform Full Sync Now.
If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified Communications
Manager, the LDAP Directory Synchronization Schedule on the LDAP Directory window determines when
the next auto-synchronization is scheduled. However, the synchronization must occur before you can associate
a new user to a device.
Step 6
Proceed to
Add User Directly to Cisco Unified Communications Manager
If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications Manager
Administration by following these steps:
Procedure
Step 1
Choose User Management > End User, then select Add New. The End User Configuration window appears.
Step 2 In the User Information pane of this window, enter the following:
• User ID: Enter the end user identification name. Cisco Unified Communications Manager does not permit
• Password and Confirm Password: Enter five or more alphanumeric or special characters for the end user
Cisco Unified IP Conference Phone 8831 and 8831NR Administration Guide
150
Identify Phone, on page
modifying the user ID after it is created. You may use the following special characters: =, +, <, >, #, ;,
\, , "", and blank spaces.
Example: johndoe
password. You may use the following special characters: =, +, <, >, #, ;, \, , "", and blank spaces.
151.
Basic Phone Administration Steps