Honda HHT25S Manual page 37

MAINTENANCE
7. Wind both lines tightly and evenly from side to side, ignoring the
ridge. Feed the line while turning the spool in the direction of the
arrow. Do not allow the lines to get twisted.
It is important to prevent the two lines from getting twisting over
each other. Position a finger between the lines as you turn the
spool to prevent the lines from twisting.
8. When you have about 6 inches (150 mm) of line remaining, press
the lines into the two notches on the bottom of the spool. This will
hold the lines on the spool for reassembly.
9. It may be necessary to push down and rotate the outer drive until
the round lugs align with the metal eyelets.
Feed both line ends through the metal eyelets in the housing.
Align the channels in the spool with the round lugs on the outer
drive. With the channels and notches aligned with the metal
eyelets, slide the spool into the housing with a continuous snap-in
motion. Be careful not to let the line slip under the spool. When the
spool reaches the bottom of the housing, the lines should snap out
of the spool notches.
If you are not sure if the lines have snapped out of the notches,
gently pull the spool away from the housing about an 1/8 inch to
inspect the lines. If necessary, gently pull each line until your hear
it snap out of the notch.
10. Hold the housing and rotate the spool in the direction of the arrow
to lock the round lug into the half-round locking hole. Trim the lines
so they are equal in length.
3-8
NOTCHES
CHANNEL (2)
OUTER
DRIVE
HHT25S•HHT35S
ROUND LUG (2)
METAL
EYELET (2)
HALF-ROUND
LOCKING HOLE