Honda HHT25S Manual page 127

FRAME ASSEMBLY / HANDLEBAR
HHT35S LOOP HANDLE / L. / R. THROTTLE
TRIGGER GRIP INSTALLATION
Adjust the handle position shown in step 2 and the throttle trigger grip
position shown in step 3 with the frame pipe assembly removed from
the engine.
1. Install the loop handle on the frame pipe.
2. Set the loop handle at a point 539 mm (21.2 in) from the end of
the engine side frame pipe as shown.
3. Install the throttle trigger grips so that the distance between the
end of the engine side frame pipe and the respective throttle
trigger grip is 81.5 mm (3.2 in) as shown, and tighten the two
5 x 20 mm screws.
TORQUE: 3 N•m (0.3 kg•m, 27 in•lb)
4. Adjust the loop handle so that it makes a right angle with the
frame pipe center line as viewed from the gear case.
5. After adjustment, tighten the four 5 x 30 mm pan head screws to
the specified torque.
TORQUE: 3 N•m (0.3 kg•m, 27 in•lb)
HANGER HOLDER INSTALLATION
Install the hanger holder in the position shown, and then tighten the
5 x 20 mm pan head screw to the specified torque.
TORQUE: 3 N•m (0.3 kg•m, 27 in•lb)
11-12
LOOP HANDLE
539 mm (21.2 in)
LOOP HANDLE
HANGER HOLDER
245 mm (9.6 in)
PAN HEAD SCREW
3 N•m (0.3 kg•m, 27 in•lb)
HHT25S•HHT35S
81.5 mm
(3.2 in)
90°
FRAME PIPE
ENGINE MOUNTING
BRACKET