Removal - Honda Acura NSX 1991 Service Manual

Timing Belt
CAUTION: Inspect the water pump when replacing the
timing belt (page IO- 11).
NOTE:
dead-center (page 6-25, 26).
tation if it is to be reused.
Disconnect the negative terminal from the battery.
2. Raise the car.
3. Remove the right rear wheel/tire.
4. Remove the engine oil cooler base assembly.
18 lb-ft)
Replace.
5. Lower the car.
6. Remove the strut bar (page 5-19).
7. Remove the intake mainifold plate.
Remove the top cover (page 5-21).
9. Remove the ignition coil covers.
10. Remove the injector cover and the wire harness
covers.
11. Remove the ignition coils and the connecters.
. NOTE:
They can be identified by the mark FF (front) or
RR (rear) printed on them.
attach a rubber seal to the intake side.
6x 1.0 mm
9 lb-ft)
16 lb-ftl
12. Remove the expansion tank.
6 x 1.0 mm'
EXPANSION
13. Remove the breather hose, and the air cleaner case
IGNITION COIL
COVER
IGNITION COIL
NOTE: Do not disconnect water hoses.
TANK
(page 5-22).
6x 1.0 mm
Do not disconnect.