Honda Acura NSX 1991 Service Manual page 67

Engine Removal/Installation
35. Remove the rear beam rod assembly.
36. Remove the front beam. Remove the A/C com-
pressor, then reinstall the front beam
the two nuts to the front beam.
NOTE:
shown. Do not let it hang from hoses.
37. Remove the left and right parking brake cables.
38. Remove the stabilizer links and separate the
damper and the suspension lower control arms.
STABILIZER
SELF-LOCKING NUT
Replace
86 Nom (8.5 kg-m, 62 lb-ft)
and retorque
V
DAMPER
SELF-LOCKING NUT
95 N-m (9.5 kg-m, 69 lb-ft)
ANTI-LOCK BRAKE
SENSOR WIRE CLAMP
39. Remove the rear brake hoses. Plug the brake pipes
with rubber caps.
40. Remove the anti-lock brake sensor wire clamps.
41. Remove the ball joints from the suspension lower
(use
control arms
and the toe control arms (use ball joint
remover 07941-6920003).
CAUTION: Make sure that the reference marks on
the control arm are aligned.
Do not remove the compressor hoses.
l
Hang
the AK compressor with wire or rope as shown.
l
Do not let it hang from hoses.
TOE
CONTROL ARM
I
BALL JOINT REMOVER
lb-ft)
ball joint remover 07MAC-
Hang
with
10 x 1.25 mm
NUT