Pedal Free Play - Honda Acura NSX 1991 Service Manual

Pedal Free Play

NOTE:
@ The clutch is self-adjusting to compensate for wear.
(0.35-0.59 in).
CAUTION: If there is no clearance between the
master cylinder piston and push rod, the release
bearing is held against the diaphragm spring, which
can result in clutch slippage or other clutch
problems.
1 . Loosen locknut A, and back off the pedal switch
until it no longer touches the clutch pedal.
2. Loosen locknut C, and turn the push rod in or out to
get the specified stroke and height at the clutch
pedal.
3. Tighten locknut C.
CLUTCH
4. Thread in the clutch pedal switch A in until it con-
5. Turn the switch in further l/4- l/2 turn.
6. Tighten locknut A.
7. Loosen locknut B and pedal switch B.
8. Measure the clearance between the floor board and
9. Release the clutch pedal 15-20 mm from the fully
10. Thread in pedal switch B in l/4- l/2 turn further.
LOCKNUT B
10 N-m (1.0 kg-m,
(5.12-5.31 in.)
mm
in.)
clutch pedal with the clutch pedal fully depressed.
depressed position and hold it there.
Adjust the position of pedal switch B so that the
engine will start with the clutch pedal in this
position.
CLUTCH PEDAL
m (1.0 kg-m, 8 lb-ft)
minimum to the floor.