Preset Torque; Inspection - Honda Acura NSX 1991 Service Manual

Preset Torque

-Inspection

On-Car:
1.
Lift up right rear wheel and place the safety stand.
(Lift and Support Points, page I-6).
Block the other three wheels.
2.
3. Measure preset torque clockwise using a torque
wrench as shown.
Standard:
Service Limits: 30 N-m (3 kg-m, 22 lb-ftl
TORQUE WRENCH
If preset torque is less than the service limit,
4.
replace the clutch discs with new ones.
NOTE: Adjust the thrust shim whenever the clutch
discs are replaced. (See page 15-8).
Assembly:
1. Place one special tool in a vise. Place the left side of
the differential assembly on the special tool, then
preset the differential with 3-5 rotations, both
clockwise and counterclockwise.
2. Measure preset torque clockwise using a torque
wrench as shown.
Standard:
Service Limit: 30 N-m (3 kg-m, 22 lb-ft)
TORQUE WRENCH
3. If preset torque is less than the service limit,
replace the clutch discs with new ones.
NOTE: Adjust the thrust shim whenever the clutch
discs are replaced. (See page 15-8).
DIFFERENTIAL
INSPECTION TOOL
DIFFERENTIAL
INSPECTION TOOL