Table of Contents
Advertisement
Commissioning instructions
Message
associated with..
MCC / MCB
Master alarm
(main control card/board)
enabled/disabled
Master alarm restored
Power supply
MCC / MCB
Master polling/not
polling at card x
MCC / MCB
Master Sector
Actioned
(main control card/board)
MCC / MCB
Master Sector
(main control card/board)
Enabled/Disabled
Device
Memory corrupt
number x loop y
Message discarded
Network Card
LPC
(loop processor card)
-
Neighbour ACK Failed
at card n
Neighbour ACK Invalid
TBA
at card n
Network Card
Network initialised
at card x
Network Insecure /
Network Card
Secure at card x
Network Card
Network starting at
card x
Network Card
Network wiring fault
at card x
MCC / MCB
New address n at
Network Card
card x
130
meaning..
The master alarm has been enabled or disabled
automatically or manually.
Master alarm fault cleared.
The ADC value should be 74.
PC or SRI (service request interface) is not
handshaking with the control panel
Master sector has been switched ON/OFF.
Master sector has been enabled or disabled manually or
automatically.
FLASH checksum failure
Message received that couldn't be routed or
understood.
Repeated address
TBA
Successful network map with polled panels.
There are 3 missing replies in a row on End-2 of the
controller.
Communication starting with other connected panels.
Wiring is presumed to be OC between
panel n and panel n.
The new address set has been read.
..possible action
If necessary, manually enable or disable the
master alarm using the [control] menu.
Check the wiring
-
If necessary manually enable or disable the
master sector.
Replace the device
Check the location displayed, try resetting card.
Check domain addresses are unique
TBA
-
Check the wiring.
Check the error rate.
-
Check the wiring.
-
4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.
Advertisement
Table of Contents
