Honeywell Vigilon 4 loop Generic Commissioning Instructions page 126

Commissioning instructions
Message associated with..
LPC
Fire number n loop y
channel z
(loop processor card)
MCC / MCB
Fire reset
(main control card/board)
Device
Flash memory checksum
error
Device
FPE Enabled /
Disabled at card x
Device
FPE w: x, y, z
MCC/ MCB / DAC/ MRC
Full keyboard Removed
/ Fitted number x
loop y
MCC / MCB
Group Enabled /
(main control card/board)
Disabled
Network
High Error rate at
Card x
Incompatible Card Any Card
Version at card x
MCC / MCB
Interface Failed at
card x
(main control card/board)
Interface input - Device
fault / restored
number x on
loop y channel z
Device
Interface Input Fire
number x on loop y
channel z
126
meaning..
Pattern match is equal to a Fire or MCP operated or
conventional detection on IO line of interface operated.
The Fire reset button has been pressed.
Speech Memory Checksum Error
All FPE Interface devices on loop x have been enabled
or disabled manually or automatically.
This information shows the FPE Interfaces on loop w
and are devices x, y and z.
The keyboard has been 'removed' (is not fitted).
A group has been automatically or manually disabled
or enabled.
High number of communication errors.
There is a card software conflict.
The interface timer chip has failed.
IO line fault.
Interface IO line triggered a fire event.
..possible action
-
-
Replace the device
Manually enable or disable all FPE Interface
devices if required.
-
Check the cable connections to the keyboard to
bring about the 'fitted' message.
If necessary, manually enable/disable the group
using the [control] menu.
Check network wiring and connections.
Fit card with compatible software.
Clear the fault and ignore single occurrence.
Replace the card on multiple failures.
Check the wiring and restore the input for
normal operation.
Check the wiring and restore the input for
normal operation.
4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.