Changing The Certified Sensor Cartridge - Honeywell Apex Technical Handbook

MAN0604_Issue 09_02-2013
2110M8030
(3) Insert a new filter.
Ensure that the filter is correctly placed in the cap the correct way round with the three lugs
closest to the front face of the cap or accessory and correctly engaged in the location points.
(4) Refit the cap or accessory.
Reverse the removal procedure.

5.2.2 Changing the Certified Sensor Cartridge

!
The Certified Sensor cartridge is located in the sensor body
and protected by the cap or accessory. This procedure allows
the cartridge to be safely changed with the unit powered-up.
Each cartridge is provided with a certificate of calibration (printed
on the reverse of the instruction sheet, Part No: 2110M8015,
supplied with the cartridge) that guarantees that the cartridge
is calibrated and ready for use.
Before installing a cartridge check that the number on the cartridge label matches the gas type and
range for the function required. A list of cartridges is given in Appendix A.
To replace a cartridge carry out the following procedure:
(1) Press esc at the Gas Reading display.
The Main Menu is displayed.
(2) Select Configuration Menu from the list.
(3) Press ok.
(4) Enter the current Level 2 password.
For information about passwords see Chapter 4.
The Configuration Menu is displayed.
5. MAINTENANCE
Change cartridges using the procedure described below.
Failure to correctly follow this procedure could result in the
wrong cartridge being installed, and possibly non-detection
of events. Alternatively, extraneous alarms could be
triggered by chemicals detected but not of concern at a
particular location.
Sensor Cartridges may contain corrosive solutions.
Dispose of according to local and national regulations.
Main Menu
Calibration Menu
Configuration Menu
Display Menu
History Log Menu
Change Passwords Menu
Reset Passwords
WARNINGS
91
Apex