Fitting The Lonworks Communication Board To The Main Pcb - Honeywell Apex Technical Handbook

Gas detection system
Hide thumbs Also See for Apex:
Table of Contents

Advertisement

MAN0604_Issue 09_02-2013
2110M8030

3.3.3 Fitting the LonWorks Communication Board to the Main PCB

(1)
Place the Main PCB Potted assembly on a flat surface with the flying lead and plug on top.
Push the flying lead to one side so that there is clear access to the Main PCB.
(2)
Remove the LonWorks Communication Board from its antistatic bag.
(3)
Position the Communication Board over the Main PCB.
Ensure the mounting pillars point downwards. Check that the two plugs on the
Communication Board are correctly aligned with the sockets on the Main PCB and the
mounting pillars are aligned with their mounting holes.
(4)
Carefully press the Communication Board down evenly onto the Main PCB.
Ensure that the pillars locate in their mounting holes and the electrical plugs are fully home.
Flying lead
3. inSTAllATiOn
Hole for communication
board mounting pillar
Ribbon
cable
Main PCB
Sockets
Main PCB
Flying lead
Main PCB
Potted assembly
Potted assembly
41
Apex

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents