Table of Contents
Advertisement
MAN0604_Issue 09_02-2013
2110M8030
Rotate the cap in an anticlockwise direction by 1/4 turn to release the bayonet fitting and
pull off.
(2)
Remove the rubber seal or filter from the sensor cap.
Lug location
Rubber seal
The rubber seal or filter is held in place in the cap by its three lugs. Carefully prise the rubber
seal or filter free from the lug location points in the cap or accessory.
(3)
For the Collecting Cone only fit the cone onto the supplied housing.
The Collecting Cone is supplied as a kit of two parts that clip together.
(4)
Fit the rubber seal/filter to the accessory.
Ensure that the rubber seal or filter is correctly installed in the accessory the correct way
round with the three lugs closest to the front face of the accessory and correctly engaged in
the locators.
(5)
Fit the accessory onto the Certified Sensor body.
Reverse the cap removal procedure. The diagram shows the Flow Housing accessory fitted
to the Certified Sensor.
3. inSTAllATiOn
Filter
46
Sensor
body
Sensor
cap
Apex
Hide quick links:
Advertisement
Table of Contents
