Installing The Gas Sensing Cartridge - Honeywell Apex Technical Handbook

MAN0604_Issue 09_02-2013
2110M8030

3.1.3 Installing the Gas Sensing Cartridge

(1) Remove the cap from the Certified Sensor body.
Rotate the cap or accessory 1/4 turn in an anticlockwise direction to release the bayonet
fitting.
(2) Fit the gas sensing cartridge into the sensor body.
Each cartridge is provided with a certificate of calibration (printed on the reverse of the
instruction sheet, Part No: 2110M8015, supplied with the cartridge) that guarantees that the
cartridge is calibrated and ready for use. Before installing a cartridge check that the number
on the cartridge label matches the gas type and range for the function required.
Caution: Only cartridges with the following part numbers can be fitted to the Certified
Sensor:
2110B30x0, 31x0, 32x0, 33x0, 34x0, 35x0 series
2110B3700 - 2110B3999 range
Note: Conforms to CSA C22.2 No. 152 only when fitted with specific cartridges. See specifications
for details.
Carefully plug the cartridge into the Certified Sensor body ensuring that the cartridge tab
lines up with the recess in the sensor body and push the cartridge, without twisting, until it is
fully home.
If the cartridge will not push fully home, re-check that the locating tab is correctly aligned with
the recess in the sensor body. Position the tab so it is resting on the tab recess wall to the
right or left of the tab recess and then turn the cartridge until the tab drops into the recess.
3. inSTAllATiOn
Sensor body
Cartridge fitted to sensor
body
Sensor cap
Sensor Cartridges may contain corrosive solutions.
Dispose of according to local and national regulations.
WARning
27
Apex