Honeywell Apex Technical Handbook page 69

MAN0604_Issue 09_02-2013
2110M8030
Configure Digital
This menu item displays a screen that reports information about digital communications if a digital
communications board is fitted to the Transmitter Unit, e.g. LonWorks. An example of a typical
screen is as follows:
Network Type
Connection Type
Node Id
Node Address
Baud Rate
Node S/W Ver
The list also provides a choice, Assert Service Pin, to bind the Transmitter Unit to the host digital
network (see 4.8).
Caution: If a Transmitter Unit is replaced, including the LonWorks PCB, the replacement
unit must be rebound to the LonWorks network. If the LonWorks PCB is removed
from a faulty Transmitter Unit and fitted into a new Transmitter Unit, then the
previous binding remains operational.
4. OPERATION
Configure Digital
Network Type:
Connection Type:
Node Id:
Node Address:
Baud Rate:
Node S/W Ver:
Assert Service Pin
Displays the type of digital network installed.
Shows the type of transceiver used for digital output.
Displays the identifier for the Transmitter Unit.
Shows the address of the unit on the digital network, if applicable.
Displays the current network communications rate.
Shows the version of the board software.
Configure Digital
ok
Configure Digital screen
Assert Service
Pin
ok
Configuration
Menu
Configuration Menu
LonWorks
FTT-10
00A176094800
N/A
78.0kbit/s
1.0
Use up/down
buttons
69
Apex