Honeywell Apex Technical Handbook page 73

MAN0604_Issue 09_02-2013
2110M8030
Second Screen
The second screen is displayed after navigating past the last entry on the initial screen by using the
down button. A typical example is as follows:
Current Config
Fault Relay:
Alarm1 Relay:
Alarm2 Relay:
Tx Version:
Sensor Version:
Fault Relay
Alarm1 Relay
Alarm2 Relay
Tx Version
Sensor Version
4.4.4 History Log Menu
The History Log Menu enables the recorded log for the unit to be viewed by the operator and
also reset, or cleared. The logcontains information about events that happen during the life of the
Transmitter Unit, e.g. time of last Certified Sensor calibration, time of last alarm, etc.
This menu is protected by a Level 2 password.
History Log Menu
View History Log
Reset History Log
4. OPERATION
NE/L
NE/NL
NE/NL
1.02
1.2
Reports the contact configuration (see Note) for the Fault Relay.
Displays the contact configuration (see Note) for the Alarm1 Relay.
Reports the contact configuration (see Note) for the Alarm2 Relay.
Displays the current version of the transmitter software.
Reports the current version of the Certified Sensor software.
Note:
The abbreviations used on the screen for the contact settings mean
the following:
nd
nE
l
nl
Normally De-energised
Normally Energised
Latching
Non-Latching
73
Apex