Cisco ONS 15454 Troubleshooting Manual page 8

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-2073 This column is permanent and cannot be removed.
EID-2074 Select one or more profiles.
EID-2075 This column is permanent and cannot be reset.
EID-2077 This column is permanent and cannot be renamed.
EID-2078 At least two columns must be highlighted.
EID-2079 The alarm types cannot be loaded into table.
There are no reachable nodes from which the list of alarm types
can be loaded.
Please wait until such a node is reachable and try again.
EID-2080 The node {0} has no profiles.
EID-2081 An error occurred while removing profile {0} from the node
{1}.
EID-2082 The profile {0} does not exist on the node {1}.
EID-2083 An error occurred while adding profile {0} to the node {1}.
EID-2085 The profile selection is invalid.
No profiles were selected.
EID-2086 The node selection is invalid.
No nodes were selected.
EID-2087 No profiles were selected.
Please select at least one profile.
EID-2088 The profile name is invalid.
EID-2089 Too many copies of {0} exist. Please choose another name.
EID-2090 No nodes were selected.
Please select the node(s) on which to store the profile(s).
EID-2091 Unable to switch to the node {0}.
EID-2092 A general exception error occurred.
EID-2093 The name is too short. It does not have enough characters.
{0}
EID-2094 The password and confirmed password fields do not match.
EID-2095 The password is invalid.
{0}
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-8
Chapter 4
Description
You cannot delete a permanent column.
You have not selected any profile or
column. Reset operation is done by
right-clicking the selected column.
A permanent column is non resettable.
You cannot rename a permanent column.
You cannot compare two profiles unless you
select two columns.
Refer to the error message text.
The specified node does not have any
profiles.
There was an error while removing the
specified profile from the specified node.
CTC cannot find the specified profile from
the specified node.
There was an error adding the specified
profile to the specified node.
You tried to select an invalid profile. Select
another profile.
You tried to select an invalid node. Select
another node.
Refer to the error message text.
The profile name cannot be empty.
Select a unique name.
You must select one or more nodes on
which you can store the profile.
CTC is unable to switch to the specified
node.
CTC encountered a general exception error
while trying to complete the task.
The name must have a minimum of six
characters.
You must make sure the two fields have the
same password.
The password you entered is not allowed.
Error Messages
78-19418-01