Cisco ONS 15454 Troubleshooting Manual page 17

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-3016 The subnet address is invalid.
EID-3017 The subnet address already exists.
EID-3019 The internal subnet address is incomplete.
EID-3020 The subnet address cannot be the same for both TSC cards.
The requested action is not allowed.
EID-3021 An error occurred while retrieving the diagnostics:
{0}
EID-3022 The requested action is not allowed.
EID-3023 The low order cross-connect mode could not be retrieved.
EID-3024 The {0} cross-connect mode could not be switched.
Please verify that the type and/or number of circuits
provisioned does not exceed the criterion for switching modes.
EID-3025 An error occurred while retrieving thresholds.
EID-3026 The send DoNotUse attribute cannot be modified.
EID-3027 The SyncMsg attribute cannot be modified.
EID-3028 The port type cannot be changed.
EID-3029 Unable to switch to the byte because an overhead change is
present on this byte of the port.
EID-3031 An error occurred while hard-resetting the card.
EID-3032 An error occurred while resetting the card.
EID-3033 The lamp test is not supported on this shelf.
EID-3035 The cross-connect diagnostics cannot be performed
EID-3036 The cross-connect diagnostics test is not supported on this
shelf.
EID-3039 An error occurred while changing the card type.
EID-3040 The card type is invalid.
EID-3041 An error occurred while applying changes.
EID-3042 The flow control low value must be less than the flow control
high value for all ports in the card.
EID-3046 The flow control watermark value must be between {0} and
{1}, inclusive.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
Refer to the error message text.
Refer to the error message text.
Enter the complete internal subnet address.
A node's internal subnet must be different
from one another as each TSC is on separate
ethernet buses, isolated by broadcast
domains.
Refer to the error message text.
The requested action is not allowed.
Refer to the error message text.
CTC cannot switch the cross-connect mode
for the specified item, as the type or the
number of circuits does not match with the
criterion for switching modes.
There was an error retrieving the thresholds.
You cannot modify the Send DoNotUse
field.
You cannot modify the SyncMsg field.
You cannot change the port type.
Refer to the error message text.
There was an error while resetting card
hardware.
There was an error while resetting the card.
Refer to the error message text.
Refer to the error message text.
The cross-connect diagnostics test is not
supported on this shelf.
There was an error while changing the card.
The selected card type is invalid.
CTC is unable to create a protection group.
Check if the protect port supports circuits, a
timing reference, SDH RS-DCC, orderwire,
or a test access point.
Refer to the error message text.
The flow control watermark value must be
between the two specified values.
4-17