Cisco ONS 15454 Troubleshooting Manual page 15

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-2215 An error occurred while leaving the {0} page.
EID-2216 An error occurred while entering the {0} page.
EID-2217 Some conditions could not be retrieved from the network view Refer to the error message text.
EID-2218 The bandwidth must be between {0} and {1} percent.
EID-2219 The protection operation failed. An XC loopback was applied
on the cross-connection.
EID-2220 The tunnel status is PARTIAL. CTC is not able to change it.
Please try again later.
EID-2221 A valid route cannot be found for the unprotected to {0}
upgrade request.
EID-2222 One or more of the following nodes are currently part of a
four-fiber {0}. Only a single four-fiber {0} is supported per
node.
{1}
EID-2223 Only one circuit can be upgraded at a time.
EID-2224 This link may not be included because it terminates on the
source.
EID-2225 A valid signal could not be detected while trying to complete
the roll.
{0}
EID-2226 The circuit roll failed.
{0}
EID-2320 This VCAT circuit does not support deletion of its member
circuits.
EID-2321 An error occurred while deleting member circuits.
{0}
WID-2322 Not all cross-connects from selected circuits could be merged
into the current circuit. They might appear as partial circuits.
EID-2323 The circuit roll failed.
Bridge and roll is not supported on monitor circuits.
EID-2324 An error occurred during the circuit upgrade.
{0}
EID-2325 You have failed {0} times to unlock this session. CTC will exit
after you click OK or close this dialog box.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
There was an error while leaving the
specified page.
There was an error while entering the
specified page.
The bandwidth must be within the specified
parameters.
As the protection operation failed, a
cross-connect (XC) loopback will be
applied on cross-connection.
Refer to the error message text.
Refer to the error message text.
The nodes, specified by {1}, are already
part of a 4-fiber MS-SPRing type (specified
by {0}).
Refer to the error message text.
Refer to the error message text.
Roll can be completed only when a valid
signal is detected. If not, the roll completion
may result in an error.
Refer to the error message text.
You can not delete a circuit that is a member
of VCAT circuit.
Refer to the error message text.
Refer to the warning message text.
A monitor circuit does not support Bridge
and Roll.
Refer to the error message text.
The maximum amount of attempts to
unlock this session has been reached.
4-15