Cisco ONS 15454 Troubleshooting Manual page 49

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-6079 A TDC entry with this TID {0} could not be removed.
Please verify that TARP is enabled.
WID-6080 Router {0} does not have an area address in common with
Router 1. Switching from IS L1/L2 to IS L1 in this case will
partition your network.
EID-6081 The limit of 10 RADIUS server entries has been reached.
EID-6082 {0} cannot be empty.
EID-6083 The entry you selected for editing has been altered by another
user. The changes cannot be committed.
EID-6084 The RADIUS server entry already exists.
WID-6085 Disabling shell access will prevent Cisco TAC from connecting
to the vxWorks shell to assist users.
EID-6086 The card cannot be changed because card resources are in use. The card you are trying to remove is being
EID-6087 The card cannot be changed because the card type is invalid or
incompatible.
EID-6088 This line cannot be put into loopback while it is in use as a
timing source.
EID-6089 The interface was not found. {0}
EID-6090 The interface type is not valid for this operation. {0}
EID-6091 The current state of the interface prohibits this operation. {0}
EID-6092 This operation is prohibited for this interface. {0}
EID-6093 The maximum number of TARP data cache entries has been
exceeded.
EID-6094 The maximum number of manual adjacency table entries has
been exceeded.
EID-6095 The AIS/Squelch mode is invalid.
EID-6096 A default IP-over-CLNS tunnel route is only allowed on a node
without a default static route and a default router of 0.0.0.0.
EID-6097 The authorization key does not comply with Cisco IOS
password restrictions.
{0}
EID-6098 A default static route is not allowed when a default
IP-over-CLNS tunnel exists.
EID-6099 You cannot create a subnet on a disabled router.
WID-6100 Disabling a router that has a provisioned subnet is not
recommended.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
You must enable TARP in order to remove
the TDC entry.
Refer to the warning message text.
CTC does not allow more than 10 RADIUS
servers.
The Shared Secrets field should not be
empty.
Refer to the error message text.
Specify another RADIUS server entry.
Refer to the warning message text.
used. Cannot change the card.
Refer to the error message text.
Refer to the error message text.
CTC cannot find the specified interface.
Choose another interface.
The port is in an invalid state to set a
loopback.
CTC does not allow this operation for the
specified interface.
You have exceeded the number of
characters permitted.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Specify another authorization key.
Refer to the error message text.
Create the subnet on an active router.
Refer to the warning message text.
4-49