Cisco ONS 15454 Troubleshooting Manual page 52

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-6144 The port provisioning cannot be changed when the port media
is Undefined.
WID-6145 OSPF on LAN should only be enabled when the LAN routers
run OSPF. Otherwise, the node will not be reachable from
outside its subnet.
RIP implementation only advertise routes in one direction to
connected routers. It does not learn or distribute routes
advertised by other routers.
Also note that enabling OSPF on the LAN will temporarily
cause the current list of static routes to stop being advertised to
remote nodes and only be used locally.
WID-6146 Deleting the protection group while in a switched state might
cause a loss of traffic. It is recommended that you verify switch
states before proceeding.
EID-6149 The LAPD MTU size must be greater than or equal to the {0}
LSP buffer size {1}. Alternatively, you can decrease the {0}
LSP buffer size to {2}.
EID-6150 The value is out of range.
EID-6151 The minimum span loss must be less than the maximum span
loss.
EID-6152 The "Use NTP/SNTP Server" field is checked. Enter the
NTP/SNTP server IP address or server name.
EID-6153 The maximum frame size is invalid.
EID-6154 To combine unidirectional two-port provisioning and
autonegotiation on the same port, autonegotiation must be set
first.
EID-6155 Transponder mode cannot be provisioned with circuits on the
card.
EID-6156 The transponder configuration is invalid.
EID-6157 The watermark values are either out of range or inconsistent.
EID-6179 The 1+1 protection group is not optimized.
EID-6196 The equipment has failed or is missing.
EID-6197 Attributes cannot be changed when the port administrative state
is {0}.
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-52
Chapter 4
Description
If the port is not pre-provisioned with the
type of media that is going to be inserted,
you cannot access any of the existing values
for the port.
Refer to the warning message text.
Refer to the warning message text.
Refer to the error message text.
Enter a value that is within the range.
Refer to the error message text.
Enter the NTP/SNTP server name. To leave
this field empty, uncheck the "Use
NTP/SNTP Server" and proceed.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The transponder is not configured properly.
Enter valid watermark values.
Refer to the error message text.
Operation is requested on a failed or
missing equipment.
You cannot change the attributes when the
port is in the specified administrative state.
Error Messages
78-19418-01