Cisco ONS 15454 Troubleshooting Manual page 33

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-3404 The far end IP address could not be set on the {0} termination.
The IP address cannot be:
loopback (127.0.0.0/8)
class D (224.0.0.0/4)
class E (240.0.0.0/4)
broadcast (255.255.255.255/32)
internal {1}
EID-3405 You cannot change card parameters with port {0} in {1} state.
Click "Reset" to revert the changes.
EID-4000 The {0} ring name cannot be changed now because a {0}
switch is active.
EID-4001 The {0} node ID cannot be changed now because a {0} switch
is active.
WID-4002 CAUTION: Reverting to an earlier software release may result
in TRAFFIC LOSS and loss of connectivity to the node. It may
require onsite provisioning to recover.
If the node was running {0} before, reverting will restore the
{0} provisioning, losing any later provisioning. If the node was
running some other version, reverting will LOSE ALL
PROVISIONING.
{1}
{2}
EID-4003 The Cisco IOS console is disabled for the card in Slot {0}.
EID-4004 An error occurred while canceling the software upgrade.
EID-4005 {0} encountered while performing a database backup.
EID-4006 The file {0} does not exist or cannot be read.
EID-4007 The size of the file {0} is zero.
WID-4008 A software upgrade is in progress.
{0} cannot proceed during a software upgrade.
Please try again after the software upgrade has completed.
EID-4009 {0} encountered while restoring the database.
EID-4010 The operation was terminated because:
{0}
EID-4011 An error occurred during provisioning:
{0}
WID-4012 Node management for {0} is not provided.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
Refer to the error message text.
Refer to the error message text.
You cannot change the ring name because a
switch of the same ring type is active.
You cannot change the ring ID because a
switch of the same ring type is active.
Refer to the warning message text.
The card may not be an IOS-based card or it
may be rebooting.
CTC encountered an error while cancelling
the software upgrade.
CTC encountered the specified error during
database backup.
Refer to error message.
The size of the file that is being backed up
or restored is zero.
The specified action cannot be performed
during a software upgrade. You must try
after the upgrade process is completed.
CTC encountered the specified error while
restoring the database.
Refer to the error message text.
Refer to the error message text.
Refer to the warning message text.
4-33