Cisco ONS 15454 Troubleshooting Manual page 57

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
WID-6291 Port has circuits; configuring the BERT mode will disrupt
normal traffic.
EID-6292 The alarm type name cannot exceed 20 characters
EID-6294 The alarm type name contains invalid characters.
Only the following characters are valid: 0-9, A-z, a-z and "-".
EID-6295 The alarm type is in use and cannot be deleted.
EID-6296 Maximum number of alarm types that can be added cannot
exceed 50.
EID-6297 Hard coded alarm types cannot be deleted.
EID-6298 The alarm type already exists.
EID-6299 The alarm type does not exist.
EID-6300 Selective auto negotiation is allowed only when
selected speed and duplex modes are non-auto.
Click "Reset" to revert the changes.
WID-6301 Selective auto negotiation applies only to copper SFPs.
EID-6302 Users are not allowed to perform this operation.
EID-6303 The ITU-T G.709 configuration cannot be disabled
when Fast Protection is enabled.
EID-6304 Users are not allowed to perform this operation.
EID-6305 The view could not be deleted.
EID-6306 The ITU-T G.709 configuration cannot be disabled
when Fast Protection is enabled.
WID-6307 You have only selected one trunk-to-trunk patchcord.
For complete deletion, you must select both patchcords
that are attached to the 10GE_XP/GE_XP cards.
Do you want to continue?
WID-6308 You have only selected one trunk-to-OCH patchcord.
For complete deletion, you must select both patchcords
that are attached to the TXP/MXP card.
Do you want to continue?
EID-6309 OCHNC circuits, OSC terminations, synchronization sources
and protection groups must be removed before you can remove
this patchcord.
EID-6310 The Committed Info Rate value must be in range [0-100].
EID-6311 The MTU value must be in range [64-9700].
EID-6312 The multicast IP address must be in range
[224.0.0.0 - 239.255.255.255]
Excluding the following IP address subranges
[(224-239).(0/128).0.(0-255)]
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
When logged in as a maintenance user
provisioning operation is not allowed.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
4-57