Cisco ONS 15454 Troubleshooting Manual page 19

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-3069 The rising threshold must be greater than or equal to the falling
threshold.
EID-3070 Error in data for ports {0} Exactly one VLAN must be marked
untagged for each port. These changes will not be applied.
EID-3071 An error occurred while retrieving the learned address list.
EID-3072 An error occurred while clearing the learned address.
EID-3073 An error occurred while clearing the selected rows.
EID-3074 An error occurred while clearing the learned address list by {0}. Error encountered trying to clear the
EID-3075 At least one row in the parameter column must be selected.
EID-3076 CTC lost its connection with this node. The NE Setup Wizard
will exit.
EID-3077 No optical link was selected.
EID-3078 An optical link could not be created.
EID-3079 Defaults cannot be applied to the node. {0}
EID-3080 CTC cannot navigate to the target tab.
{0}
EID-3081 The port type cannot be changed.
EID-3082 The {0} extension byte cannot be changed.
EID-3084 An error occurred while retrieving laser parameters for {0}.
EID-3085 No OSC Terminations were selected
EID-3086 One or more Osc terminations could not be created.
EID-3087 The OSC termination could not be edited.
EID-3088 No {0} card is present to switch.
EID-3089 The {0} state cannot be used or changed when the {1} has
failed or is missing.
EID-3090 The operation cannot be performed because the {0} is
{1}LOCKED_ON/LOCKED_OUT.
EID-3091 The operation cannot be performed because the protect card is
active.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
Refer to the error message text.
CTC encountered data error for the
specified ports. Only one VLAN should be
marked untagged for each port.
Unable to retrieve the learned MAC address
from the NE.
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
learned MAC address from either a VLAN
or a port.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
CTC cannot apply the defaults to the
specified node.
CTC cannot go to the specified target tab.
Refer to the error message text.
You cannot modify the specified extension
byte.
There is no card, or there was an internal
communications error when attempting to
get the laser parameters for the card.
Select an OSC termination and proceed.
Refer to the error message text.
Refer to the error message text.
No card of the specified type is available to
switch.
You cannot use or change the specified state
when the card is failed or missing.
You cannot perform operation.
Refer to the error message text.
4-19