Cisco ONS 15454 Troubleshooting Manual page 50

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-6101 The MAT entry already exists.
WID-6102 The new card has less bandwidth than the current card. Circuits
of size VC11 and larger will be deleted.
EID-6103 The TDC entry already exists.
EID-6104 APC ABORTED.
EID-6105 The 'Change Card' command is valid for MRC cards only when
Port 1 is the sole provisioned port.
EID-6106 To delete all RADIUS server entries, RADIUS authentication
must be disabled.
EID-6107 The node failed to restart the TELNET service on the selected
port. Try using another unreserved port that is not being used
within the following ranges:
23, 1001-9999 (with the exception of 1080, 2001-2017, 2361,
3081-3083, 4001-4017, 4022, 4081, 4083, 5000, 5001, 7200,
9100, 9300, 9401).
EID-6108 That port is already in use.
EID-6109 A section trace is active on the trunk port. The action cannot be
completed.
EID-6110 The maximum number of TARP requests has been reached.
EID-6111 The card in Slot {0} cannot be removed from the protection
group while its traffic is switched.
EID-6112 An error occurred while adding a shelf: {0}
EID-6113 An error occurred while deleting a shelf: {0}
EID-6114 The maximum number of supported shelves has already been
provisioned.
EID-6115 There are bad or duplicate shelf positions.
Valid rack numbers are {0} to {1}.
Valid rack positions are {2} to {3}.
EID-6116 CTC attempted to access an OCH-Trail connection that has
been destroyed.
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-50
Chapter 4
Description
Refer to the error message text.
Refer to the warning message text.
Specify another entry for TARP Data
Cache.
Automatic Power Control is aborted.
Refer to the error message text.
Disable Radius authentication and proceed.
Refer to the error message text.
Restart a TELNET session.
Actions such as putting the port in an
incomplete state are not permitted while a
section trace is active.
You have exceeded the maximum number
of TARP requests.
Refer to the error message text.
The shelf ID specified is invalid or already
exists, the equipment does not support
multishelf, the specified shelf position is
out of range, or the specified shelf position
is already in use.
One or more of the equipment modules
(provisioned virtual links, provisioned
server trails, provisioned protection groups,
or provisioned DCCs) in the shelf is
currently in use. Delete cards from all the
slots and try again.
Refer to the error message text.
Refer to the error message text.
Software has prevented an attempt to access
an OCH trail.
Error Messages
78-19418-01