Cisco ONS 15454 Troubleshooting Manual page 48

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-6055 The IP address is already in use.
EID-6056 The SNMP trap destination is invalid. {0}
WID-6057 Changing the card mode will result in an automatic reset.
EID-6058 The maximum number of IP-over-CLNS tunnels has been
exceeded.
EID-6059 The specified IP-over-CLNS tunnel already exists!
EID-6060 An error occurred while trying to {0} an IP-over-CLNS tunnel
entry:
{1}.
EID-6061 An error occurred while deleting the IP-over-CLNS tunnel
entry.
EID-6062 The selected IP-over-CLNS tunnel does not exist.
EID-6063 The selected router does not exist.
EID-6064 The MAA address list is full.
EID-6065 The selected area address is duplicated.
EID-6066 The primary area address cannot be removed.
EID-6067 The selected area address does not exist.
EID-6068 The IP-over-CLNS NSEL cannot be modified while there are
IP-over-CLNS tunnel routes provisioned.
EID-6069 The node is currently in ES mode. Only Router 1 can be
provisioned.
EID-6070 No router was selected.
EID-6071 The TARP data cache cannot be flushed.
EID-6072 The TARP data cache entry cannot be added:
{0}
WID-6073 A TARP request has been initiated.
Try refreshing the TARP data cache later.
EID-6074 End system mode only supports one subnet.
EID-6075 An error occurred while trying to remove a MAT entry. The
entry does not exist.
EID-6076 An error occurred while trying to {0} a TARP manual
adjacency entry:
{1}
EID-6077 The area address must be between 1 and 13 bytes long,
inclusive.
EID-6078 A TDC entry with this TID {0} does not exist in the table.
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-48
Chapter 4
Description
Refer to the error message text.
The specified SNMP trap destination is
invalid. Choose another destination.
Refer to the warning message text.
Refer to the error message text.
Specify another IP Over CLNS tunnel.
Refer to the error message text.
CTC encountered an error while deleting
the IP Over CLNS tunnel entry.
Create a IP Over CLNS tunnel.
Create a router.
Refer to the error message text.
Enter another area address.
Refer to the error message text.
Choose another area address.
You cannot change the NSEL address if
tunnels are provisioned.
An End System needs only one provisioned
router.
Select a router.
You cannot flush the cache in the Tunnel
identifier Address Resolution Protocol
(TARP) state.
You cannot add the specified cache entry.
Refer to the warning message text.
Refer to the error message text.
CTC is removing the MAT entry.
CTC cannot add the specified adjacency
entry for reasons unknown.
The area address should not be more than 13
characters.
The specified Tunnel Identifier does not
exist.
Error Messages
78-19418-01